> Карданный. Nissan Terrano II (with 1985 on 1999 of release)
Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
12.1. Specifications
12.2. Coupling - the general data
12.3. A coupling pedal - removal, installation and adjustment
12.4. The main cylinder of coupling - removal, dismantling and installation
12.5. The working cylinder of coupling - removal, dismantling and installation
12.6. The dempfernyj cylinder of coupling - removal, dismantling and installation
12.7. A coupling hydrodrive - removal
12.8. Details of the mechanism of coupling - removal, dismantling and installation
12.9. The vyzhimnoj bearing - replacement
12.10. The directing plug of a primary shaft of a check point - replacement
12.11. A kardannyj shaft, a reducer and the back bridge - the general data
12.12. Карданный
12.13. An average support - replacement
12.14. Kardannye hinges - replacement
12.15. Полуось, the back wheel bearing and an epiploon - removal and installation.
12.16. A reducer of the back bridge - removal and installation
12.17. An epiploon of a leading gear wheel of a reducer - replacement
12.18. The back bridge - removal and installation
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







12-12-kardannyjj.html

12.12. Карданный

1. Lift also a back part of the car.
2. Designate mutual position of flanges of back section карданного a shaft and a leading gear wheel of a reducer (photo).
3. Turn away four bolts of fastening of a flange of back section with a flange of a leading gear wheel of a reducer.
4. On two-section карданном a shaft turn away bolts of fastening of an average support.
5. Displace карданный a shaft and disconnect from a back flange, then lower and deduce карданный a shaft from a transmission.
6. Muffle an aperture in a transmission,
7. Installation is carried out upside-down. Combine the labels put at removal.

«The previous page
12.11. A kardannyj shaft, a reducer and the back bridge - the general data
The following page»
12.13. An average support - replacement