Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
12.1. Specifications
12.2. Coupling - the general data
12.3. A coupling pedal - removal, installation and adjustment
12.4. The main cylinder of coupling - removal, dismantling and installation
12.5. The working cylinder of coupling - removal, dismantling and installation
12.6. The dempfernyj cylinder of coupling - removal, dismantling and installation
12.7. A coupling hydrodrive - removal
12.8. Details of the mechanism of coupling - removal, dismantling and installation
12.9. The vyzhimnoj bearing - replacement
12.10. The directing plug of a primary shaft of a check point - replacement
12.11. A kardannyj shaft, a reducer and the back bridge - the general data
12.12. Карданный
12.13. An average support - replacement
12.14. Kardannye hinges - replacement
12.15. Полуось, the back wheel bearing and an epiploon - removal and installation.
12.16. A reducer of the back bridge - removal and installation
12.17. An epiploon of a leading gear wheel of a reducer - replacement
12.18. The back bridge - removal and installation
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







12-10-napravlyayushhaya-vtulka-pervichnogo-vala-kpp-zamena.html

12.10. The directing plug of a primary shaft of a check point - replacement

1. The directing plug is a support of a primary shaft of a check point and запрессована in an aperture in a back flange коленвала. A plug condition it is necessary to check every time when coupling acts in film. If there are doubts concerning a plug condition it is necessary to replace it.
2. Remove a transmission (Gl. 7А).
3. Remove coupling.
4. Wipe the plug and check up a condition, having shined the plug an aperture.
5. Выпрессуйте the plug (photo).
6. In the absence of a special stripper for выпрессовывания plugs remove the plug by means of hydroblow For this purpose fill deepening in коленвале with dense greasing, carefully having removed air, and strike on оправке, inserted into the plug. Diameter оправки should be not less than internal diameter plugs (photo). Get the plug and remove all greasing.
7. Запрессуйте the new plug. The distance from external edge of the plug to a flange surface коленвала should be And = 4 mm (photo).
8. Establish coupling and a transmission.

9.8 Installation of the new directing plug 1. The directing plug


10.1 Kardannyj a shaft And - Models 3S63H, 3S80B and 3S71A 1. An average support 2. A washer 3. A flange 4. Back section of a shaft 5. Forward section of a shaft 6. A collar of an average support 7. An arm 8. Крестовина 9. A lock ring 10. The bearing



«The previous page
12.9. The vyzhimnoj bearing - replacement
The following page»
12.11. A kardannyj shaft, a reducer and the back bridge - the general data