Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
11.1. Specifications
11.2. The general data
11.3. Draught of management of transmission - adjustment
11.4. The blocking switch - check and adjustment
11.5. Kick-down - the switch - adjustment
11.6. A rod of a vacuum diaphragm - adjustment
11.7. A back epiploon - replacement
11.8. Automatic transmission - removal and installation
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







11-5-kick-down-pereklyuchatel-regulirovka.html

11.5. Kick-down - the switch - adjustment

1. The switch is intended for food giving on an electromagnetic drive of transition to a hill-climbing gear by pressing a pedal throttle заслонки to the full. If the switch is not adjusted, switching on a hill-climbing gear occurs at partially open throttle заслонке.

4.3 Typical scheme of connection kick-down - the switch


5.4 Adjustment of a rod of a vacuum diaphragm 1. A saddle (the valve should be pressed to a saddle)     2. A wall картера Z.Shtok 4. A plate of the case of the throttle valve 5. The throttle valve


2. Include ignition and press a pedal throttle заслонки to the full, - characteristic click thus should be listened.
3. If click is absent, release a counternut (the switch is mounted over a pedal), press a pedal to the full and submit the switch before click (at an emphasis to the probe).
4. Tighten a counternut and check up adjustment.
5. If the switch is adjusted, but switching on a hill-climbing gear does not occur, check up short circuit of contacts of the switch and presence on it pressure.
6. If pressure is present also contacts become isolated, address in car-care centre for check of a chain of the switch and an electromagnetic drive.

«The previous page
11.4. The blocking switch - check and adjustment
The following page»
11.6. A rod of a vacuum diaphragm - adjustment