> The general data. Nissan Terrano II (with 1985 on 1999 of release)
Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
11.1. Specifications
11.2. The general data
11.3. Draught of management of transmission - adjustment
11.4. The blocking switch - check and adjustment
11.5. Kick-down - the switch - adjustment
11.6. A rod of a vacuum diaphragm - adjustment
11.7. A back epiploon - replacement
11.8. Automatic transmission - removal and installation
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







11-2-obshhie-dannye.html

11.2. The general data

On cars 4-speed transmissions which type is defined by the wheel formula and engine type are established. The gear change is carried out depending on speed of movement and depression in a soaking up collector. On transmissions RE4R01A or RL4R01A cars 1990 and are provided the device of automatic switching of transmission at an overload of the engine and the blocked hydrotransformer 1991. These transmissions are equipped by self-diagnostics system.
The transmission selector can be in one of 6 following positions.
Р - the parking, in this position is started the engine for performance of all adjusting works on the working engine. To translate the selector in this position during movement it is forbidden. It is used for a parking on biases.
R - a reverse gear
N - neutral position, in this position is started the engine and can is long to idle during movement on the loaded line.
About (on a part of cars) - transmission switching at an engine overload, joins automatically at switch operation (on 4-cylinder engines) or at position of the switch of capacity of the engine in position Auto (on engines V6).
D - in this position the lever is translated at driving in a usual mode.
"2" - the car moves on 2nd transfer, is used on steep slopes and descents, and also at movement on a wet covering. In this position the engine tests the maximum loadings.
"1" - in this position transmission is switched to 1st or 2nd transfer at speed more low or above 40 km/hour, accordingly. It is used for effective braking by the engine on abrupt biases.
Repair of automatic transmission is carried out only in car-care centre. However, it is independently possible to remove this unit and to replace. If the car is maintained in the conditions of heavy traffic at air temperature above 30 ° With, in a hilly terrain or is often used as towing to change a liquid follows through each 24000 km (instead of 48000). A liquid cooler (it is located in the bottom part of a radiator is washed out in car-care centre. At unsatisfactory work of transmission before to draw a conclusion on malfunction of its internal device will perform adjusting more low adjusting and verifying works.

2.3а the Counternut of draught of transmission in cars with the floor selector (all-wheel drive а/м 1988 and all rear-wheel а/м since 1987) 1. Counternuts


2.3б a draught Counternut in all-wheel drive cars with the floor selector of 1987 of century 1. Counternuts        2. A screw coupler 3. Not to press



«The previous page
11.1. Specifications
The following page»
11.3. Draught of management of transmission - adjustment